Noby-uk Noby-65 Manuel d'utilisateur télécharger pdf (Page 11)

Noby-65 Installation Manual & Operating Instructions (Rev.1) Page 11 of 12

USER OPERATING INSTRUCTIONS

Exit Procedure:

Full-Set:

• Check that only the green Power LED is lit.

• Turn the Keyswitch to FULL-SET.

• All LEDs illuminate for 2 seconds, followed by a continuous Exit Tone.

• Proceed directly to the Final Exit Door. Do not stray off the Exit Route.

• Leave the premises and listen for the Exit Tone to stop.

Part-Set:

• Check that only the green Power LED is lit.

• Turn the Keyswitch to PART-SET. Zone-2 is isolated and the Zone-2 LED will flash slowly.

• All LEDs illuminate for 2 seconds, followed by a continuous Exit Tone.

• Proceed directly through the Exit Route to the night-time living area (Zone-2).

• Listen for the Exit Tone to stop.

Note: All existing alarm conditions must be clear before attempting to arm the intruder system.

The Noby-65 will abort the Exit procedure in the event of a system fault or alarm, and the buzzer will

emit a rapid pulsing tone. Perform a System Reset to clear the LEDs and try again.

Entry Procedure:

• Open the Final Exit Door. A slow pulsing Entry Tone will commence.

• Proceed immediately to the Noby-65 control panel. Do not stray from the Entry Route

• Turn the Keyswitch to OFF. The Entry Tone will stop.

Following an Intruder Alarm:

• Turn the Keyswitch to OFF. The Siren and Internal Buzzer will silence.

• Observe and note the red LEDs.

• Perform a System Reset.

To clear latched PIR LED indications:

• Turn the Keyswitch to FULL.

• Allow the Exit Time to finish.

• Turn the Keyswitch to OFF.

System Reset:

• Momentarily turn the Keyswitch to FULL and then to OFF within 2s.

• Observe a 2s LED test.

Note: If the cause of an alarm still persists then the alarm will re-trigger immediately following a System Reset.

To Silence the Alarm:

• Turn the Keyswitch to FULL for 4 seconds.

• Turn the Keyswitch to OFF.

Following a Fire Alarm or Water Alarm:

• CARRY OUT THE PRESCRIBED EMERGENCY PROCEDURE

Only when it is safe to continue:

• Silence the alarm.

• Observe and note the red LEDs, which will identify the cause of the alarm.

• Perform a System Reset.

Cleaning:

Clean external surfaces with a damp cloth and mild detergent. Do not use abrasives, solvents or polish.



1 2 ... 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Noby-uk Noby-65 Manuel d'utilisateur Page 11

Commentaires sur ces manuels